scrappystickyinkymess


16 Comments

The humble roll of waxed paper

You know me by now – if I see something I am ALWAYS going to cast my eye across my craft room and see if I have something that I can make do with cause I really HATE shopping.  I was looking at glassine paper, and the examples of Kraft glassine in Tim’s new book and I thought What do I have that has those same properties? Well DUH! Waxed paper.

Check it out:

I assembled my supplies – waxed paper, Distress inks and stains, Staz-on (or Archival ink, I expect) and a stamp I have had forever and never used.

I started by crumpling the waxed paper. You can do it a lot or a little – the creases are what will give you the effect.

Open it out and smear on Distress Stains in any colour or in a few colours. Give it a moment to sink in – you can blot with a paper towel and go over it again for deeper colour. It will bead up on the waxy parts – feel free to work it into the creases with the paper towel.

My waxed paper is waxier on one side.  You can work the ink in to one side, then flip it over and do the same on the other.  Frankly I find it hard to tell which side is best so I usually wind up doing both! Now iron it between a couple of pages of a notebook – I keep one on my ironing board for this (cause you KNOW I don’t iron clothes!)

Ironing the waxed paper gives it a sort of flexible vellum-like quality.  It is pretty floppy after the ink but it firms up well after you iron it. Stamp your image and colour in the bits yo want with Distress ink and a water pen.  Iron it again cause it’ll be wet now.

I also tinted the edges and pressed the back into some droplets of watery ink left on my craft mat. I like that effect.

Here is the final card:

I think the next bit will surprise you!  How DID I get the waxed paper to stick to the card?  So simple – unlike vellum you really can’t see the adhesive thru the waxed paper.  The ATG gun worked a treat!  I’ll get to that in a moment.

Next I did the same thing with Vintage Photo.Not sure how well you can see, but the left is JUST the stain, as above.  The RIGHT has Vintage Photo DI smudged over the surface, after the ironing removed the wax.

I doubt you will be able to see this super clearly but I’ll give it a go.  It’s best to apply the adhesive to the tag, rather than the waxed paper.  It could rip if you are not careful.  Try to get right to the edges – I did better on the right then on the left.

Stick on the waxed paper and trim. I defy you to see any obvious adhesive thru the waxed paper!

I’ve turned this into a simple tag by stamping over it with black Staz-on

Then I thought back to the tissue tape ruffle I’ve seen and again thought Wonder if….? Yep, it sure does.

Crumple and ink a strip of waxed paper, as before. Iron. Stick it to a sheet of plain paper and trim with scalloped scissors (the plain paper supports the thinner waxed paper, making the cutting easier.  Frankly You could just leave the edge straight – one you ruffle it you don’t really see the scallops much.

I lay a strip of double-sided tape down, sticky side up, backing still on.  Pleating and sticking the waxed paper strip gives me this!

I stuck that to the bottom edge of the tag and added a few little bits and this is it:

The bee was stamped then the wings painted with Liquid Pearls and the body stripes with yellow Stickles.  I stuck it popped at the head end, but with its body stuck flat.  and the little one was stuck just in the center, with the wings folded up:

I know that was a pretty massive post, but I really wanted you to see how well this works.

Get some waxed paper. Have a play.  I think you’ll be surprised what you can do with it.

Have a crafty weekend!